MaxStream 9XTend-PKG-E Guia de Instalação descarregar pdf (Página 4)

XTEND 900 MHZ WIRELESS MODEM

For use with VEEDER-ROOT EMR³ DATALINK

INSTALLATION INSTRUCTIONS

Manual 577013-859, Rev. B

Veeder - Root

Page 4 of 13

For XTend Modem: Green is RX, Black is TX, White is Ground, Red is V+

Upon completion of the wiring and power to the IB is turned on, the red light on the modem next to the

RS-232 connector will be on.

Before leaving the vehicle, go to the display, and make sure the PORT 2 ASSIGN under

SETUP, SYSTEM ADDRESS is set to OBC.

x Push the MODE button to get to SETUP, Arrow Up to SYSTEM ADDRESS, NEXT to IB

ADDRESS, Arrow up to PORT 2 ASSIGN, NEXT, if not OBC the Arrow to OBC and ENTER,

ENTER, and ENTER. You can then push the MODE button to get back to Volume Mode.

RS-232

special

cable

RS-232

Connect:

Green RX

Black TX

White

Ground

Red V+

Red to

V+

V+ from

Vehicle

V-

Battery

Ground

Red Light on

with Power

to IB

1 2 3 4 5 6 7 8 9 ... 12 13

Sem comentários

MaxStream 9XTend-PKG-E Guia de Instalação Página 4